Wall Paints & Tints

ProNature Wall Paint

Area of Use
Interior and exterior* waterborne natural resin based wall finish.

Where to use ProNature Wall?


Use ProNature Wall for the finishing of all mineral substrates (plaster, concrete etc.) and organic substrates (wall paper, wood etc.)

  • ProNature Wall Paint Colour Chart
  • Download Technical Data Sheet ProNature Wall

    As ProNature Wall does not contain biocides normally found in conventional paints an exterior use might at times not be advisable if walls are not protected from permanent moisture i.e. shaded walls in coastal regions. Permanent moisture on wall coated with ProNature Wall might become subject to growth of algae or mould. Under normal circumstances these areas can easily clean up with a solution of ProNature Plant Soap, borax, Hydrogen peroxide or ProNature Mould Stop.
 

 

Colour Chart

  100 80 60 40 20 10 5 1
Green Green 100 Green 80 Green 60 Green 40 Green 20 Green 10 Green 5 Green 1
Blue Blue 100 Blue 80 Blue 60 Blue 40 Blue 20 Blue 10 Blue 5 Blue 1
Black Black 100 Black 80 Black 60 Black 40 Black 20 Black 10 Black 5 Black 1
Red Red 100 Red 80 Red 60 Red 40 Red 20 Red 10 Red 5 Red 1
Yellow Yellow 100 Yellow 80 Yellow 60 Yellow 40 Yellow 20 Yellow 10 Yellow 5 Yellow 1
Pumpkin Pumpkin 100 Pumpkin 80 Pumpkin 60 Pumpkin 40 Pumpkin 20 Pumpkin 10 Pumpkin 5 Pumpkin 1
Terra Cotta Terra Cotta 100 Terra Cotta 80 Terra Cotta 60 Terra Cotta 40 Terra Cotta 20 Terra Cotta 10 Terra Cotta 5 Terra Cotta 1
Choco Choco 100 Choco 80 Choco 60 Choco 40 Choco 20 Choco 10 Choco 5 Choco 1
Other colours
available:
Reseda 1 - 100
Patina 1 - 100
SkyBlue 1 - 100
Azura 1 - 100


 The colours shown are as close as possible to the actual paint colour, but should only be seen as a guidline, as a consistent colour display cannnot be achieved on computer screens. Please view our colour charts at our outlets or the factory for more exact colours.


Surface Preparation     
All surfaces must be clean, chemically neutral, dust- and oil free.

Previously unpainted, newly plastered or very absorbent surfaces need to be primed with ProNature Plaster Primer before finishing coats of ProNature Wall are applied. Fill holes and cracks with a suitable material before ProNature Plaster Primer and ProNature Wall is applied. Crack fillers should always be primed with ProNature Plaster Primer before application of ProNature Wall .

Fill holes and cracks with a suitable material before ProNature Wall is applied.
 

 

Application


ProNature Wall is ready for use. For priming ProNature Wall may be diluted with max. 20% water. The paint can be applied by brush, roller, foam pad or suitable spraying equipment. Allow 4 - 6 hours drying time (depending on ambient temperatures) between coats, when subsequent coats are desired. Under normal circumstances a dual coat with undiluted ProNature Wall is sufficient.

ProNature Wall fully dries within 24 hours and reaches its final maturity after about 4 weeks. Before applying ProNature Wall over existing coatings like eggshell enamels and other synthetic finishes ensure that the previous finish has a sound adhesion. Always remove loose finishes thoroughly and pre-sand high gloss finishes. Clean tools with water.

Storage
A minimum of 4 months in unopened containers when stored in a cool and frost-free place. Product does not contain chemical preservatives and hence might be subject to micro bacterial decomposition. Once opened product has a limited shelf life and preferably should be used immediately. Do not use material if it has an unpleasant smell or shows signs of a micro bacterial attack i.e. mould.

Curing and Touch-ups
Unlike synthetic wall finishes based on acrylics or similar polymers which dry by evaporation i.e. loss off water and solvents, natural wall paints based on plant oils dry by evaporation and oxidation. Oxidation is the absorption of oxygen. This explains why ProNature Wall will take longer to become dry to the touch and to fully mature. The speed of oxidation also depends on ambient temperatures and good ventilation i.e. paints dry and cure faster at warmer temperatures. As minor colour differences between batches may occur it is advisable to do touch-ups corner to corner and not just in a single spot. Colour differences will also occur as the paint matures and cures. Touch-ups with the same batch may be visible but normally blend in as the touched-up areas cure.



Coverage
Approximately 6 m2 per litre, on non-porous, flat substrate.


Package Sizes
1 l, 5 l and 20 l


Ingredients
Water, Calcium carbonate, Kaolin, Pigments of natural occurrence or non toxic mineral pigments, Linseed oil, Sunflower oil, Casein, Borates, Gum rosin, Cellulose ether, Essential oils.



Package Sizes
1 l, 5 l and 20 l


Wall Paints & Tints  >  Wall Paint  I  Plaster Primer  I  Lime Casein Paint