|
|
| Wall Paints & Tints |
 |
|
ProNature Plaster Primer
Area of Use |
Interior and exterior waterborne natural resin based plaster primer and wall finish.
Where to use ProNature Plaster Primer? |
Use the ProNature Plaster Primer for the pre-treatment of very absorbent or unevenly absorbing mineral substrates (plaster, concrete etc.) and organic substrates (wall paper, wood, rhino board etc.) as well as for additional protection against staining and soiling over ProNature Wall substrates or clay walls, crete stone, etc. and for the priming of very absorbent surfaces before ProNature Wall is applied.
Colours: White and Clear.
Download Technical Data Sheet ProNature Plaster Primer
|
 |
| |
Surface Preparation |
 |
Wood should be finely sanded and all surfaces must be clean, dust- and oil free. Care must also be taken to provide a neutral surface. Therefore it is recommended to pre-treat mineral surfaces with an acid wash (follow supplier instructions!). As a natural acid wash simply use some vinegar or citric acid (15%) dissolved in water. Rinse acid washed surfaces well and leave to dry. Fill holes and cracks with a suitable material before ProNature Plaster Primer is applied. |
|
Application
|
ProNature Plaster Primer is ready for use. The plaster primer can be applied by brush, roller, foam pad or suitable spraying equipment. Allow 12- 24 hours drying time (depending on ambient temperatures) between coats or before over-coating with ProNature Plaster Primer fully dries within 24 hours and reaches its final maturity after about 4 weeks. Clean tools with water. For partially dried product assist water cleaning with ProNature Plant Soap.
Storage
A minimum of 4 months in unopened containers when stored in a cool and frost-free place. Product does not contain chemical preservatives and hence might be subject to micro bacterial decomposition. Once opened product has a limited shelf life and preferably should be used immediately. Do not use material if it has an unpleasant smell or shows signs of a micro bacterial attack i.e. mould. |
|
Coverage
|
Approximately 15 m2 per litre, depending on absorbency of substrate.
|
|
Package Sizes
1 l, 5 l and 20 l |
|
 |
Ingredients
|
Water, Linseed oil, Wood oil, Colophony Ester, Casein, Borates, Essential oils
|
|
Package Sizes
1 l, 5 l and 20 l |
|
|
|
|
|
|
|
