ProNature Table Top
Area of Use |
A blend of plant oils for treating and waterproofing wooden table tops, counters and working surfaces.
Where to use ProNature Table Top? |
Use ProNature Table Top for the impregnation and protection of table and kitchen tops, bar counters and all other wooden surfaces which are subject to frequent use, contact with water or waterbased materials.
|
|
Colours Available
|
|
General Information |
 |
ProNature Table Top is ready to use and needs not be diluted. Depending on the wood type a thinning down of the first coat with about 10 % of ProNature Plant Turpentine may be required. Clean brushes and equipment with ProNature Plant Turpentine.
Natural coatings have the added advantage not to contain any ingredients, which could cause harmful emissions, like formaldehyde or aromatic solvents, which could increase the risk of cancer. |
|
Surface Preparation |
|
 |
Clean surface and sand wood to a very fine, smooth finish using grit i.e. 180, preferably finer 220 or higher. |
|
Application
 |
Stir material well before application. ProNature Table Top is applied liberally using a brush or short bristle paint roller or simply by wiping or dipping.
Depending on the absorbency of the wood apply ProNature Table Top until complete saturation is reached using the wet in wet process. |
Once saturation is reached remove any excess thoroughly using a lint-free cloth or any suitable machinery. Drying time is approximately 12 hrs.
To further improve on the water resistance it is recommended to apply a very thin layer of ProNature Table Top after a drying time of 12 hrs by simply wiping on the material with a lint-free cloth. Remove any excess and leave to dry.
 IMPORTANT: The water resistance of the coating will only be reached after approximately seven days and will further improve with age.
Cold weather and high humidity will retard the drying process. |
 |
Coverage
|
Approximately 9 - 14 m2 per litre, depending on wood type.
|
 |
Package Sizes
0.5 l, 1 l, 5 l and 25 l
0.5 l, 1 l and 5 l are available at Hardware Stores. |
|
|
|
Care and Repair
|
|
The durability of oiled wooden working surfaces highly depends on regular cleaning and care. For the first two weeks tops should not be subject to standing water. Thereafter the tops can receive normal cleaning with a neutral soap, e.g. ProNature Plant Soap and water.
Tops should receive aftercare using ProNature Table Top regular intervals at least three times a year or once the surface appear partially dry and lustreless and in need of nourishment. Apply sparingly and wipe of any excess thoroughly and leave to dry.
ProNature Table Top is spot repairable and should small damages from wear or scratching occur just clean the area thoroughly using
ProNature Plant Turpentine where necessary, and sand concerned area lightly with a very fine sandpaper, i.e. grit 600 or a scouring pad. Remove dust and apply a thin layer of ProNature Table Top with a soft cloth following above instructions. The treated area should not be subject to wet cleaning for 48 hours. |
|
Ingredients |
Linseed oil, plant oils, essential oils and lead-free driers.
Please note: Natural products are not odour and emission free, please consider possible allergies.
|
|
Package Sizes
0.5l, 1 l, 5 l and 25 l
0.5l, 1 l and 5 l are available at Hardware Stores. |
|
 |
|
