Use ProNature Wax Balm for the universal treatment of furniture, toys, wooden ceilings, wall panelling, wooden floors as well as mineral substrates like slate, stone counter-tops, etc.

Download Technical Data Sheet ProNature Wax Balm

General Information

ProNature Wax Balm is ready to use and needs not be diluted. Clean brushes and equipment with ProNature Plant Turpentine.

Surface Preparation

Clean surface and sand wood to a fine, smooth finish using grit i.e.150-180, preferably finer. Surface must be dry, clean and dust-free.

Application

Depending on the surface, apply 1 - 2 coats of ProNature Wax Balm using a soft, lint-free cloth. Remove surplus with a clean piece of soft cloth, and polish the surface thoroughly. If a higher quality finish is desired, apply an additional coat after drying. The final hardness of the finish is only reached after a few days of drying. When applied to wooden floors, treat the floors during this period carefully and avoid the engraining of dirt.

Maintenance of oiled/waxed Floors:

Remove grit, dust and other loose dirt. Clean the floor with ProNature Plant Soap solution and well wrung out scouring cloth. Alternatively a cleaning machine with the least amount of water possible may be used. Wipe dry immediately. Moisten cloth with ProNature Wax Balm and apply sparingly until the whole floor is covered. Alternatively apply the ProNature Wax Balm using a polishing pad of a floor polishing machine. It is important to apply as little ProNature Wax Balm as possible. Remove surplus with a clean piece of soft cloth or polishing pad and polish the surface thoroughly. Polishing should commence not earlier than an hour after applying ProNature Wax Balm and higher sheen is acquired by allowing ProNature Wax Balm to set for a couple of hours. A strict maintenance routine should be established of at least three times per year or when ever necessary. It is important to remove all excess wax thoroughly!

Coverage

Ingredients